Finally
While it is upside down, attach the diagonal braces. These should be cut from a 2x4. They should be cut with a ~ 17 degree angle roughly 44 inches per side. These should be cut to fit.
Make sure the legs are square with the top, the braces will hold them square. Set these offset from each other so you can nail into each of them from opposite sides of the center cross board. Nail them into the seat stretchers as well, when you are sure the length will hold the legs square. Now flip the table right side up and nail two 2x4's between the seat stretchers. Finally nail the two 2x10 seats in place on top of the seat stretchers and the 2x4 seat supports.Before nailing these in place, measure the distances between the stretchers so again you are ensuring the table is square.
Finishing
You can leave the table with no finish and it will weather a light grey, or you can apply a sealer a stain or paint.
Average (2 Ratings)

1 Comment
LEAVE YOUR COMMENT
You must sign in to leave a commentcharacter(s) remaining